Table of Contents
Advertisement
1. When adjusting the rear disc gangs laterally, it is best
to set the center gang first and then sequentially set
the rear gangs on the wing assemblies secondarily.
2. When adjusting the center section rear gang
assembly, it may be necessary to first adjust the wing
gang assembly in the direction the adjustment is
being made.
3. While the typical row unit spacing is 10", the spacing
between the row units at the fold break is
approximately 10-3/8".
W
Compound Shank Adjustment
W
TABLE OF CONTENTS
10"
Hybrid Shank Adjustment
Figure 4-3: Lateral Adjustment of Gang Assemblies (1 of 2)
Rear Hinge Gap
10-3/8"
10-3/8"
Default Front
Hinge Gap
Figure 4-4: Lateral Adjustment of Gang Assemblies (2 of 2)
OPERATION AND MAINTENANCE
•
Once the center section rear gang assembly is
adjusted and secured in place, the wing rear
gang assemblies should be set relative to the
center section rear gang assembly.
4. The wing rear gang assemblies should be adjusted
so the first row unit adjacent to the nearest center
section rear row unit is 10-3/8" on center from it.
Figure 4-4
14"
Vertical Shank Adjustment
Rear Hinge Gap
10-3/8"
10-3/8"
Default Front
Hinge Gap
10"
10"
T ypical Row Spacing
See
4-7
Advertisement
Table of Contents
