Nautilus Schwinn IC3 Service Manual page 33

3. Using a 16mm socket and wrench, remove the Flange Nut (C) under
the threaded Cap (B).
4. Thread the Crank Puller into the Crank Arm (A). When the Crank
Puller is in the correct position, only 1-2 threads on the outer portion (CP2)
of the Crank Puller should show.
Note:
with the inner surface (CP2) as shown, before use.
5. Using a15mm wrench, turn the inner portion (CP3) of the Crank
Puller clockwise. The Crank Arm (A) will slide off as it is tightened. Discard
the old parts.
6. Installation is the reverse procedure. Installation does not require the
use of the crank puller. Be sure the Crank Arms are connected at 180°
from each other.
To reinstall the Pedals, carefully align the threads and hand tighten to
prevent cross-threading. Then tighten fully with pedal wrench.
Note: The Left Pedal is reverse-threaded. Orientation is based
from a seated position on the bike. The Left Pedal has an "L",
the Right Pedal an "R".
7. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully
assembled and inspected for correct perfor
mance in accordance with the Owner's Manual.
A
C
CP1
33
CP2 CP3