Table of Contents
Advertisement
Disconnect the data cable from the console before you service this machine.
Note: Your machine may not match the image. For reference only.
1.
Using a #2 Phillips screwdriver, loosen and remove the hardware
that attaches the Fender to the Main Frame. Set the Fender and hardware
safely aside for reassembly.
NOTICE: Hold the Fender so that it does not fall.
2.
Carefully remove the Fender and set it safely aside for reassembly.
NOTICE: Do not crimp the cable.
3.
Loosen the Resistance Knob (A) to the minimum resistance setting.
4.
Using a 10mm open end wrench, loosen the hardware (B1) that
attaches the Brake Assembly (B) to the Frame Mount (C). The screw
holes in the Brake Assembly arm are slots to let you adjust the position of
the arm on the Frame Mount.
5.
Move the Brake Assembly (B) on the Frame Mount (C) as necessary.
Hold it in position and tighten the hardware.
6.
Tighten the Resistance Knob (A) and inspect the Brake Assembly
movement. Adjust the Brake as necessary.
7. Reinstall the Fender.
NOTICE: Do not crimp the cable.
8.
Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully
assembled and inspected for correct
performance in accordance with the Owner's
Manual.
14
A
A
C
Hide quick links:
Advertisement
Table of Contents
