Adding Accessories - Yale HSA6200 Installation, Programming, Operating

Adding accessories

To provide additional protection you can add extra door/window contacts, PIRs, keyfob
remote controls, keypad remote controls, help buttons and smoke detectors. These are
available separately from your local stockist.
Adding devices for the first time
See section 3 for adding extra devices in preparation
for first time system installation.
Adding devices to an already installed
system
The installed system will be controlled by either a
keyfob(s) or a keypad(s).
Keypad
1 Press button "A" followed by the user PIN code
to enter test mode indicated by a continuously
flashing LED.
2 Press button "A" followed by "2" to switch off the
system tamper while installing the new device, the
siren will beep in response.
3 Press button "A" followed by "4" to put siren
into learn mode, the siren will beep and flash in
response.
4 Press device learn/test buttons (see section 3,
step 2 onwards) to trigger learning-in signals, the
siren will beep and flash when each device is learnt
in.
5 When all the devices have been learnt in, press
button "A" and "5" to quit learn mode.
• Learn-in mode will automatically time out after 3
minutes.
6 When installation is finished press button "A" and
"3" to rearm tamper protection.
• Tamper protection will automatically rearm after 1
hour.
7 Press Disarm twice to exit.
14
Keyfob
1 Press the Arm and Home buttons together and
continuously for 5 seconds until the LED stops
flashing, to switch off the tamper while installing
the new device. The siren will beep in response.
2 Press the Home and Emergency buttons together
and continuously for 5 seconds until the LED stops
flashing, the siren will beep and flash in response.
3 Press device learn/test buttons (see section 3,
part 2) to trigger learning-in signals, the siren will
beep and flash when each device is learnt in.
4 When all the devices have been learnt in press and
hold the Disarm button to quit learn mode.
• Learning in mode will automatically time out after 3
minutes.
5 Press the Arm and Emergency buttons together
and continuously for 5 seconds until the LED stops
flashing to rearm tamper protection.
• Tamper protection will automatically rearm after 1
hour.