Installation Instructions - Belling Cookcenter 150 Installation & User's Instructions

Fig. 1
INSTALLATION WITH WALL CUPBOARDS
IN LINE WITH SIDES OF APPLIANCE
Fig. 2
INSTALLATION OF COOKER HOOD
The appliance is type X with regard to protection against overheating dependent on the
location decided by the user, (see Fig. 3).
We do not recommend positioning the cooker below wall cupboards, as the heat and
steam from the cooker may cause damage to the cupboard and its contents.
Excess steam from the oven vents out of the grille at the rear of the hob, so make sure
that the walls behind and near the cooker are resistant to heat, steam and condensation.
4

Installation Instructions

The cooker can be close fitted below hotplate level. This requires a
minimum distance of 1090mm between cupboard units of hotplate
height.
Follow the diagrams below for guidance on fitting. Take note of all
dimensions.
1090
1090
1200
1090
Fig. 3
INSTALLATION ALONGSIDE TALL
CUPBOARDS OR SIDEWALL
1090
Fig. 4
INSTALLATION CLOSE TO A CORNER
Appliance
135 min
1090
If your appliance is to be fitted close to a
corner ensure that there is a clearance of
135mm minimum. This will enable you to
fully open the door and allow removal of
oven shelves.
150
d
Cupboar