Flex 45 Degree Channel (Flk 45D) - Acclaim Lighting Ai Flex Interior User Manual

FLEX 45 DEGREE CHANNEL (FLK 45D)

This low profile channel holds the Ai Flex tape at 45 degrees to the mounting surface. The
Ai Flex 45 degree channel can be wall/ceiling mounted or alternatively suspended by wires
or rods. Clear, opal and frosted lens options are available. For channel dimensions, see page
32.
Options
Flex 45 degree channel
(3.28' / 1m)
[FLK 45D]
Steel rod with
threaded ends
[1.64' / 0.5m: FLK PEN SR05]
[3.28' / 1m: FLK PEN SR1]
TO FIT THE AI FLEX TAPE
1 If necessary, cut the channel to the length required. Ensure that any resulting burrs are
removed.
2 Ensure the tape mounting surface within the channel is completely dry, clean and free of
grease. If cleaning is required, please see page 4 for details.
3 Determine the length of tape required. Leave at least a 10mm gap at each
end to allow the end caps to be inserted. Mark the positions at each
end of the channel where the tape will be placed.
Note: Ai Flex tape can only be cut every 6.5" (166mm),
which may constrain the precise lengths of tape that
can be achieved. Therefore it may be beneficial
to center the tape within the channel to achieve
an even distribution.
4 Cut the tape to the nearest marked
cutpoint.
5 Begin peeling the backing from the
Ai Flex tape and carefully stick the Ai Flex tape into the channel, starting at the marked
position.
IMPORTANT: While pressing the Ai Flex tape into position, take care not to put
excessive pressure on the components or connections.
8
Lenses (3.28' / 1m)
[Clear: FLK MFC]
[Frosted: FLK MFL]
[Opal: FLK MOL]
Stainless steel wire
[3.28' / 1m:
FLK PEN SSW1]
1 0 m
Conductive
fastener
[FLK 45D CF]
End cap
[FLK 45D EC]
m
www.acclaimlighting.com
Zinc mounting
bracket
[FLK 45D ZMB]
End cap
with hole
[FLK 45D ECH]