DMX CHANNEL DESIGNATIONS
The various AL Dot variants apply their LED emitters to DMX channels in different ways, as
summarized in the table below.
DMX
3000K
1
White
2
3
4
The channel allocations above are shown beginning at DMX address 1. When you configure
a fixture with an alternative DMX address, that value will become the first channel in the list
shown above and the other channels will increment from there.
MAKING A TEMPORARY CONTROL LINK
Each XMT-350 DMX/RDM tool is supplied with a 5-pin male XLR lead that can be used to
make a temporary control input link with the AL Dot feed-in cable. Use a 3-pin terminal
block, wire nuts, conn blocks or Wago® connectors to temporarily join the two cables:
Male XLR
lead from
XMT-350
4000K
White
www.acclaimlighting.com
RGB
Spectrum RGBW
Red
Green
Blue
White (3000K)
Red
Green
Blue
AL Dot
feed-in
cable
9