Digi-Sense TC9600 Advanced User Manual page 13

PID Control Mode Setup
Screen # 12 - Over Temperature Stop
Use UP/DOWN arrow keys to change the value.

When sensor temperature goes above this value, the output

device will be turned off.
When complete, press MENU key to advance to screen # 13.

Screen # 13 - Loop Break Stop
Default value is ENABLED. Use UP/DOWN arrow keys to

change the value.
Loop Break Stop is a feature that will stop the process output

while the controller is in the run mode. If the controller senses
there is no change in temperature in a user set amount of time, the output will be turned off and
error message will be displayed on the screen along with an audible alarm.
Set to DISABLED if this function is not required.

When complete, press MENU key to advance to screen # 14.

Screen # 14 - Control Action
Use UP/DOWN arrow keys to change the value.

Set for the process that is being performed: Heat or Cool

When complete, press MENU key to advance to screen # 15.

Screen # 15 - Control Mode
Use UP/DOWN arrow keys to change the value.

Default value is PID mode. (If different, select PID mode)

When complete, press MENU key to advance to screen # 16.

1.800.561.8187
:
13
www. .com
information@itm.com