Digi-Sense TC9100 Calibration Manual

Advanced temperature controllers

Advertisement

Calibration Manual
Digi-Sense
®
TC9100 and TC9600
Advanced Temperature Controllers
Models: 89800-11, 89800-12, 89800-13 & 89800-14
THE STANDARD IN PRECISION MEASUREMENT
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TC9100 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Digi-Sense TC9100

  • Page 1 Calibration Manual Digi-Sense ® TC9100 and TC9600 Advanced Temperature Controllers Models: 89800-11, 89800-12, 89800-13 & 89800-14 THE STANDARD IN PRECISION MEASUREMENT...
  • Page 2 Introduction Each temperature controller has built into the operation menus a calibration gateway. This gateway allows the temperature controller to be calibrated to six temperature points, allowing for consistent and accurate temperature readings. The calibration process allows for both full-range calibration and segmented calibration. Each unit comes preloaded with tested default calibration temperature points.
  • Page 3 Segmented Calibration Segmented Calibration allows you to calibration between any two temperatures along the full range of the probe, providing a more accurate reading between those temperatures. For example, placing all six (6) calibration points between 0.0 °C and 600 °C will yield more accurate temperature readings between those temperatures than the full-range calibration would.
  • Page 4 Calibration Mode Setup Equipment requirements: Fluke 753 or equivalent calibrator for use in thermocouple and RTD calibration, and an IET decade box for thermistor calibration. Step Instruction Screen Step 1 Connect the calibrator to the appropriate temperature connector on the back of the controller Step 2 Start input sensor type and the specific sen-...
  • Page 5 12/17 Rev 1.0...

This manual is also suitable for:

89800-12Tc960089800-1189800-1389800-14

Table of Contents