Dismantling And Rinsing The Professional Fine Foam Frother - Jura S8 Quick Reference Manual

S8 – Quick Reference Guide
Dismantling and rinsing
the professional fine
foam frother
4
T Add milk system cleaner to the front part of the container
up to the bottom mark (indicated by 6).
T Then fill with water up to the upper mark.
T Place the container under the fine foam frother.
T Connect the milk pipe to the container.
E To connect the milk pipe to the container correctly, the pipe
must be fitted with a connector.
T Touch 'Next'.
'Milk system is being cleaned'
The operation is interrupted,
T Rinse the container thoroughly and fill the front part with
fresh water up to the upper mark.
T Place this under the fine foam frother and reconnect the
milk pipe to the container.
T Touch 'Next'.
'Milk system is being cleaned'
The operation stops automatically.
To make sure the professional fine foam frother works properly, and
in the interests of hygiene, it must be dismantled and rinsed daily if
you have been preparing milk.
T Remove the milk pipe and rinse it thoroughly under running
water.
T Remove the professional fine foam frother.
1
2
'Fresh water'.