Dismantling And Rinsing The Fine Foam Frother; Dismantling And Rinsing The Professional Fine Foam Frother - Jura WE8 Instructions For Use Manual

5 Maintenance
Dismantling and rinsing
the fine foam frother
Dismantling and rinsing
the professional fine
foam frother
32
T Press the 'Next'
'Milk system is being cleaned'
frother and the milk pipe are cleaned.
'Clean the milk system'
T Rinse the container thoroughly and fill the front part with
fresh water up to the upper mark.
T Place this under the fine foam frother and reconnect the
milk pipe to the container.
T Press the 'Next'
'Milk system is being
milk pipe are rinsed with fresh water.
The operation stops automatically.
To make sure the fine foam frother works properly, and in the inter-
ests of hygiene, it must be dismantled and rinsed daily if you have
been preparing milk. Your JURA will not prompt you to dismantle
and rinse the frother.
T Remove the milk pipe and rinse it thoroughly under running
water.
T Carefully remove the fine foam frother from the Connector
System © by twisting slightly.
T Dismantle the fine foam frother into its individual parts.
T Rinse all the parts under running water. If there are severely
dried-on milk residues, firstly immerse the individual parts
in a solution of 250 ml cold water and 1 capful of JURA milk
system cleaner. Then rinse the parts thoroughly.
T Re-assemble the fine foam frother.
E Ensure that all individual parts are correctly and firmly con-
nected to ensure optimum operation.
T Firmly attach the fine foam frother to the Connector Sys-
tem © .
To make sure the professional fine foam frother works properly, and
in the interests of hygiene, it must be dismantled and rinsed daily if
you have been preparing milk. Your JURA will not prompt you to dis-
mantle and rinse the professional fine foam frother.
T Remove the milk pipe and rinse it thoroughly under running
water.
button.
appears and the fine foam
/ 'Fresh water'
button.
cleaned', the fine foam frother and the