Table of Contents
Advertisement
▶ The power connections must be as short as possible in order
to protect the system against overloading; for example,
during a storm.
▶ Connect the appliance to the power supply via a separate
socket with an earth connection.
7
Commissioning
7.1 Before commissioning
NOTICE: Damage to the appliance!
After installing the appliance in its final
position, wait at least 30 minutes before
switching it on.
NOTICE: Do not start the appliance without
water!
▶ Only operate the appliance once it has
been filled with potable water.
▶ Check whether the cylinder is filled with water.
▶ Check all connections for tightness.
▶ Check the electrical connection.
7.2 Switching the appliance on/off
Switching ON
▶ The appliance must be connected to the power supply via a
separate socket with an earth connection.
For the first few seconds after switching on, the display will
not be activated.
Once the compressor has been started, the
appliance must run for at least 5 minutes
before it can be switched off again.
Compress 3000 DW FII
Normal start
Time
Activity
0 - 1 minutes Water temperature check (circulation pump in
operation)
1 - 2 minutes Wait mode
2 - 4 minutes Air temperature check (fan in operation)
> 4 minutes
Compressor in operation
Table 9
Switching off
▶ Switch off the appliance at the power connection.
NOTICE: Damage to the appliance!
Minus temperatures can cause the water to
freeze.
▶ Do not interrupt the power supply. This
will ensure that the "frost protection"
function keeps working.
▶ Set the appliance to the "Off" operating
mode ( chapter 8.4.4, page 19).
-or-
▶ Drain the appliance fully.
8
Operation
1
2
Fig. 13 User interface
[1] Display
[2] Selector keys
Commissioning | 17
6720804054-16.1V
6 720 809 134 (2013/09)
Hide quick links:
Advertisement
Table of Contents
