Commissioning; Environmental Protection And Disposal - Bosch Compress 3400i AWS Installation Manual

Outdoor unit of air to water heat pump
Hide thumbs Also See for Compress 3400i AWS:
Table of Contents

Advertisement

CAN-BUS
CAN-BUS: do not connect at "Out 12V DC" (12V direct voltage output)
on the main PCB of the indoor unit.
Maximum cable length 30m
Minimum diameter Ø = 0.75mm
The outdoor unit and the indoor unit are connected by a communications
wire, CAN-BUS.
2
A LIYCY cable (TP) 3x0.75mm
extension cable outside of the unit. Alternatively, twisted pair cables
approved for outdoor can be used. One of the shielded ends must be
connected to the nearest grounding terminal in the indoor unit structure.
The other end cannot be connect to the groundings or any metal part of
the outdoor unit structure.
The connection between the circuit boards is by three wires. The circuit
boards have markings for the CAN-BUS connections.
Fig. 21 CAN-BUS connection
[1]
Indoor unit
[2]
Outdoor unit
Power supply to the outdoor unit
Use exclusively H05RN-F (60245 IEC 57) cable for all power supply
connections to the outdoor unit.
The circuit breaker must be able to disconnect all poles with 3mm
contact opening.
ODU
Circuit breaker
CS3400iAWS 4 OR-S,
16A
CS3400iAWS 6 OR-S and
CS3400iAWS 8 OR-S
CS3400iAWS 10 OR-S
20A
Table 8 Cable types
Compress 3400i AWS – 6721825369 (2021/11)
2
(or equivalent) is suitable as an
1
Out 12V DC
CAN high
CAN low
gnd
GND
Can L
Can H
N
L
2
0010036947-001
Power supply
cable
2
3x2.5mm
2
3x2.5mm
6

Commissioning

When all steps of the previous chapter are completed, all pipes and
cables must be taped.
Fig. 22 Taping
The protective cardboard from the fan can be removed and the heat
pump is ready to start up.
▶ Conduct a test run to confirm that the system was installed without
abnormalities.
▶ Explain to the customer how to operate the unit and remind that
operation instructions should be kept for future reference.
7

Environmental protection and disposal

Environmental protection is a fundamental corporate strategy of the
Bosch Group.
The quality of our products, their economy and environmental safety are
all of equal importance to us and all environmental protection legislation
and regulations are strictly observed.
We use the best possible technology and materials for protecting the
environment taking account of economic considerations.
Packaging
Where packaging is concerned, we participate in country-specific
recycling processes that ensure optimum recycling.
All of our packaging materials are environmentally compatible and can be
recycled.
Used appliances
Used appliances contain valuable materials that can be recycled.
The various assemblies can be easily dismantled. Synthetic materials are
marked accordingly. Assemblies can therefore be sorted by composition
and passed on for recycling or disposal.
Old electrical and electronic appliances
This symbol means that the product must not be disposed
of with other waste, and instead must be taken to the waste
collection points for treatment, collection, recycling and
disposal.
The symbol is valid in countries where waste electrical and
electronic equipment regulations apply, e.g. "European Directive 2012/
19/EC on old electronic and electrical appliances". These regulations
define the framework for the return and recycling of old electronic
appliances that apply in each country.
As electronic devices may contain hazardous substances, it needs to be
recycled responsibly in order to minimize any potential harm to the
environment and human health. Furthermore, recycling of electronic
scrap helps preserve natural resources.
For additional information on the environmentally compatible disposal
of old electrical and electronic appliances, please contact the relevant
local authorities, your household waste disposal service or the retailer
where you purchased the product.
You can find more information here:
www.weee.bosch-thermotechnology.com/
Commissioning
1
0010037042-001
17

Advertisement

Table of Contents
loading

Table of Contents