Mitsubishi MELSEC QCPU Programming Manual page 154

6 BASIC INSTRUCTIONS
[Operation Errors]
(1) There are no operation errors associated with the =, <>, >, <=, <, or >= instructions.
[Program Example]
(1) The following program compares the data at X0 to XF with the data at D3, and turns Y33 ON if
the data is identical.
[Ladder Mode]
(2) The following program compares BIN value K100 to the data at D3, and establishes continuity
if the data in D3 is something other than 100.
[Ladder Mode]
(3) The following program compares the BIN value 100 with the data in X0 to XF, and establishes
continuity if the D3 data is less than 100.
[Ladder Mode]
(4) The following program compares the data in D0 and D3, and if the data in D0 is equal to or
less than the data in D3, establishes continuity.
[Ladder Mode]
6 - 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
[List Mode]
Steps Instruction
[List Mode]
Steps Instruction
[List Mode]
Instruction
Steps
[List Mode]
Instruction
Steps
MELSEC-Q/QnA
Device
Device
Device
Device
6 - 3