Rikon Power Tools 50-114 Operator's Manual page 6

CONTINUED FROM PAGE 5
If a properly grounded electrical receptacle is
not available, an adapter as shown in FIGURE B
can be used to temporarily connect this plug to
a 2-contact ungrounded receptacle. The adapter
has a rigid lug extending from it that MUST be
connected to a permanent earth ground, such as a
properly grounded receptacle box.
THIS ADAPTER IS PROHIBITED IN CANADA.
EXTENSION CORDS
clear of the working area. Position the cord
so that it will not get caught on lumber, tools
or other obstructions while you are working
with a power tool.
before each use. If damaged replace im-
mediately. Never use a tool with a damaged
cord, since touching the damaged area could
cause electrical shock, resulting in serious
injury.
SPECIFIC SAFETY INSTRUCTIONS FOR SANDERS
This machine is intended for the surfacing of natural, solid woods and composite materials. Any other
use not as specified, including modification of the machine or use of parts not tested and approved by
the equipment manufacturer can cause unforeseen damage, and invalidate the warranty.
ATTENTION: Use of this sander still presents risks that cannot be eliminated by the manufacturer.
Therefore, the user must be aware that wood working machines are dangerous if not used with care
and all safety precautions are adhered to.
1. Do not operate this machine until you have read all of the following instructions.
2. Do not attempt to operate this machine until it is completely assembled.
3. Do not turn ON this machine if any pieces are damaged or missing.
4. This machine must be properly grounded.
5. If you are not familiar with the operation of the machine, obtain assistance from a qualified
person.
6. It is highly recommended that this machine be firmly mounted to a flat and secure work surface
or stand.
7. Always wear protective eye wear prior to operating this machine.
8. Always wear a dust mask and use adequate dust collection and proper ventilation. Use of
sanders can produce harmful particles while sanding certain types of woods.
9. Do not wear loose clothing or jewelry when operating this machine. Keep long hair tied back.
Page 6
SAFETY INSTRUCTIONS
Keep the extension cord
Check extension cords
FIG. B
Use a proper extension cord. Only use cords
listed by Underwriters Laboratories (UL). Other
extension cords can cause a drop in line voltage,
resulting in a loss of power and overheating of
tool. When operating a power tool outdoors, use
an outdoor extension cord marked "W-A" or "W".
These cords are rated for outdoor use and reduce
the risk of electric shock.