Rikon Power Tools 50-114 Operator's Manual page 16

CONTINUED FROM PAGE 15
To replace the sanding disc if the table and disc cover need to be removed:
1. Remove the disc worktable and then
remove the disc cover (A) by removing the
four screws holding it in place (B).
See page 10 for table instructions.
2. Remove the existing sanding disc, and
clean any residue left on metal disc plate (C).
See page 15 for instructions on this step.
3. Peel the plastic backing from the new
PSA sanding disc and carefully press the
disc firmly in position around the metal sand-
ing plate. Make sure the disc is centered on
the plate.
4. Reinstall the disc cover, tighten the four
screws, and place the sanding table and
safety disc cover back onto the machine.
REPLACING THE SANDING BELT
1. Remove the belt worktable. See page 10
and 11 for reference.
2. Remove the belt sander support rod (A).
See page 14 for reference.
3. Position the belt work support frame
horizontally as shown. Loosen the inner hex
screw (B) by using the supplied 5 mm hex
wrench, turning it counterclockwise. Do not
remove the screw.
4. Remove the two screws (C, D) by using
a Phillips screwdriver, and pull out the
tension lever (E) to release the tension of the
sanding belt (F). Remove the belt exhaust
cover (G).
5. Remove the sanding belt from both
sanding drums (H).
6. Place new sanding belt over sanding
drums. Make sure the belt arrow located
on the inside of the belt is pointed in the right
direction.
7. Replace the belt exhaust cover (G) back
in position on the machine.
Page 16
MAINTENANCE
CONTINUED ON PAGE 17
FIG. 14
C
B
A
FIG. 15
G
D
E
G
B
C
F
H
I
A