Table of Contents
Advertisement
52
en | Configure VIDEOJET connect 7000 to Operate with a MIC7000 Camera
15
Configure VIDEOJET connect 7000 to Operate with a
MIC7000 Camera
To configure alarm inputs and outputs, audio, and video playback for a MIC7000 camera, that
camera must be "bound" to Camera 1 in the Transcoder Setup in the SETTINGS page of
VIDEOJET connect 7000.
15.1
Configure Alarm Inputs and Outputs
To configure alarm inputs and outputs for a camera "bound" to Camera 1, follow these steps:
4
4
Note: The Interfaces menu, which displays alarm inputs and outputs (alarm I/O), appears only
in the configuration menu of the camera "bound" to VIDEOJET connect 7000 (the camera for
which the value in the field Application variant is set to "[camera name] – VJC-7000").
15.2
Configure Audio
To configure audio for a camera "bound" to Camera 1, follow these steps:
4
4
4
Note: The page Camera > Audio (in the configuration menu between Miscellaneous and Pixel
Counter) appears only in the configuration menu of the camera "bound" to VIDEOJET connect
7000.
15.3
Configure Video Playback
To configure video playback with VIDEOJET connect 7000, first you must map the device to
record. See Recording for details.
2019-08 | 1.7 | F.01U.291.524
On the camera, verify that the value in the field Application variant is set to "[camera
name] – VJC-7000." (Access the field from Camera > Installer Menu in the web browser
of the camera.) This variant will align the appropriate parameters of the camera with the
parameters of VIDEOJET connect 7000.
In the device VIDEOJET connect 7000, verify that the parameters "Show alarm inputs"
and "Show alarm outputs" are selected in the menu Web Interface > LIVE Functions.
On the camera, verify that the value in the field Application variant is set to "[camera
name] – VJC-7000." (Access the field from Camera > Installer Menu in the web browser
of the camera.) This variant will align the appropriate parameters of the camera with the
parameters of VIDEOJET connect 7000.
In the device VIDEOJET connect 7000, select the Transmit audio check box in the menu
Web Interface > LIVE Functions.
In the device VIDEOJET connect 7000, set the Input volume in the menu Transcoder >
Audio.
Installation Manual
Videojet connect 7000
Bosch Security Systems
Advertisement
Table of Contents
