Status; Last Error; Recording Target; Bit Rate - Bosch VJC-7000-90 Installation Manual

38 en | Recording
The data in the fields in this window may be followed by an icon. Move the cursor over the
icon to show more details about each field.
10.3.1

Status

This field provides the status of the remote video device. Status descriptions include "Offline,"
"Recording," and "Running."
10.3.2

Last error

This field identifies when the last error occurred on the remote video device.
10.3.3

Recording target

This field identifies the recording target for the respective camera. This target is also the
source for the recordings available on the PLAYBACK page.
10.3.4

Bit rate

This field identifies the bit rate of the recording for the remote video device.
10.3.5

Initialize Recording

Note: This is only required if the Transcoder is going to Manage the recordings. Otherwise, the
recording settings of the connected device will apply.
To configure VIDEOJET connect 7000 to manage recordings, you must initialize the recordings.
4
4
Recording Profiles
Select the desired Recording Profiles. Recording mode as it affects the defaults to be set.
Note that only the Day tab on the Recording Profiles page is overwritten, that is the tab
marked green.
- Pre-alarm
The best stream profile and the maximum pre-alarm time for RAM recording together with a
minimum post-alarm time are selected, all available alarm triggers are activated, and metadata
is included in recording.
- Continuous
The best stream profile is selected for recording, pre- and post-alarm times are deleted, all
available alarm triggers are deactivated, and metadata is included in recording.
Recording Scheduler
The scheduler is set to 24/7 recording with the Day recording profile.
VCA
If the camera supports IVA software, this is set as analysis type and activated to detect any
object in the scene. Otherwise, the motion detector is activated configured to monitor the
entire area for even small objects with high sensitivity.
4
10.3.6

Start/Stop Recording

4
2019-08 | 1.7 | F.01U.291.524
Click Initialize Recording for the respective device. The Configuration window appears.
(To initialize recording for all connected devices at once, click Initialize All.)
In the Configuration window, mark the SETTINGS page of the remote video device that
you want to configure with the recording defaults of VIDEOJET connect 7000. Generally,
this means that a simple basic configuration is set which grants you most effective
recording that also supports forensic search:
Click Set to save the settings. The recording target is the one defined in the transcoder.
Only recordings to this target will now be available on the PLAYBACK page.
Click the respective button to start or stop the recording for a camera.
Installation Manual
Videojet connect 7000
Bosch Security Systems