Alarm Outputs; Washer Pump - Bosch VJC-7000-90 Installation Manual

Videojet connect 7000
9. Connect Alarm inputs, if applicable.
–
–
–
Pin
1
2
3
Note: You can use a zero potential closing contact or switch as the actuator. If possible, use a
bounce-free contact system as the actuator.
–
–
–
–
5.8

Alarm Outputs

* Note: This feature is valid only for a MIC7000 camera "bound" to Camera 1.
10. Connect Alarm outputs, if applicable.
–
–
–
Pin
1
2
3
–
–
5.9

Washer Pump

* Note: This feature is valid only for a MIC7000 camera "bound" to Camera 1.
11. Connect the washer pump drive, if applicable.
–
–
–
Pin
1
2
–
Bosch Security Systems
Prepare the cable as needed.
Feed the cable through an appropriate cable gland or conduit hole near where the 6-pin
terminal plug connector for alarm inputs will be installed on the PCBA (item 8).
Make the connections for alarm inputs (for external devices such as door contacts or
sensors) to the connector according to the table below.
Description / Function
Alarm 2
Ground
Alarm 3
Make the connection for the supervised alarm input (Alarm 1), if applicable, to pin 7 of
the 7-pin terminal plug connector for alarm outputs (item 7 on the PCBA).
Attach a 2.2K ohm (Ω) end-of-line terminating resistor (user-supplied).
Check that the connections are secure.
Carefully press the connector to the appropriate location on the PCBA.
Prepare the cable as needed.
Feed the cable through an appropriate cable gland or conduit hole near where the 7-pin
terminal plug connector for alarm outputs will be installed on the PCBA (item 7).
Make the connections for relay outputs (for switching external units such as lamps or
alarm sirens) to the connector according to the table below.
Description / Function
Ground
Alarm Output 1
Ground
Check that the connections are secure.
Carefully press the connector to the appropriate location on the PCBA.
Prepare the cable as needed.
Feed the cable through the cable gland or conduit hole near where the 2-pin terminal
plug connector for the washer pump connections will be installed on the PCBA (item 2).
Make the connections to the connector according to the table below.
Description / Function
Relay Normally Open
Relay Common
Check that the connections are secure.
Pin
4
5
6
Pin
4
5
6
Installation Manual
Installation | en
Description / Function
Alarm 4
Ground
Alarm 5
Description / Function
Alarm Output 2
Alarm Output 3
Ground
2019-08 | 1.7 | F.01U.291.524
23