Product Overview - Bosch VJC-7000-90 Installation Manual

Videojet connect 7000
3

Product Overview

The device VIDEOJET connect 7000 (VJC-7000-90) is a full-featured network power supply
unit that can operate a variety of Bosch PTZ cameras such as MIC7000. The device includes
one (1) HPoE network connection, two (2) standard network interfaces for connections to
additional IP devices, one (1) slot for an optional CompactFlash (CF) memory card, two (2)
slots for use with SFP-based fiber optic modules, alarm/washer control interfaces*, and audio
in.
Specification
Power requirements
Alarm inputs *
Alarm outputs *
Audio *
Washer driver output *
Washer switch *
Communication
Local storage
SFP (small form-factor pluggable) Two (2) slots for use with SFP-based fiber optic modules
The device provides the following features:
–
–
–
–
* Note: This feature is valid only for a MIC7000 camera "bound" to Camera 1.
Bosch Security Systems
connector 3.5 mm stereo jack
signal line in 9 kohm typical, 5.5 Vpp max. 25
signal line out 3.0 Vpp at 10 kohm typical;
HD-Base T PoH dedicated for one RJ45 Ethernet connection between the device and a
Bosch IP camera powered by PoE/High PoE
a push button on the PBCA to allow users to activate/test a connected washer pump
accessory * (optional, user-supplied)
ability to control connected cameras using the built-in web browser of the device
support for daisy chaining a maximum of 50 units (based on specific conditions)
Value
100 VAC - 240 VAC (90 VAC - 264 VAC with tolerance
considered), 50/60 Hz; 56V output
Four (4) normal dry contacts (selectable N.O./N.C.)
Monitored supervised alarm input (Alarm 1), 2.2K ohm
(Ω) end-of-line terminating resistor
Three (3) open collector outputs, 32 VDC, 150 mA
One (1) mono line in; one (1) mono line out
2.3 Vpp at 32 ohm typical;
1.7 Vpp at 16 ohm typical
Dry contact relay, 250 V, 5 A
Push button to activate/test the washer relay
momentarily
Three (3) 10BASE-T/100BASE-TX/1000Base-TX.
If SFP fiber optic modules installed: two (2) 1000 BASE-
FX
One (1) slot for an optional CompactFlash (CF) memory
card, Type I / Type II, True IDE Mode, 1 TB max (user-
supplied)
(1 GB only) as recommended in the section Optional
Accessories, page 10
Installation Manual
Product Overview | en 11
2019-08 | 1.7 | F.01U.291.524