Unpacking; Parts List; Additional Tools Required; Additional Hardware Required - Bosch VJC-7000-90 Installation Manual

10 en | Unpacking
2

Unpacking

–
–
–
–
2.1

Parts List

Each device ships with the following parts:
–
–
–
2.2

Additional Tools Required

Installers must provide the following items to complete installation of VIDEOJET connect
7000.
–
–
2.3

Additional Hardware Required

–
–
–
–
–
2.4

Optional Accessories

–
2019-08 | 1.7 | F.01U.291.524
This equipment should be unpacked and handled with care. Check the exterior of the
packaging for visible damage. If an item appears to have been damaged in shipment,
notify the shipper immediately.
Verify that all the parts listed in the Parts List below are included. If any items are
missing, notify your Bosch Security Systems Sales or Customer Service Representative.
Do not use this product if any component appears to be damaged. Please contact Bosch
Security Systems in the event of damaged goods.
The original packing carton is the safest container in which to transport the unit and must
be used if returning the unit for service. Save it for possible future use.
One (1) VIDEOJET connect 7000 enclosure with three (3) M16 plugs, three (3) ¾"
blanking plugs, and five (5) M16 gland locknuts installed
Parts bag with:
– one (1) terminal plug connector, 2-pin [for connections to optional washer]
– one (1) terminal plug connector, 3-pin [for AC mains power input]
– one (1) terminal plug connector, 6-pin [for alarm inputs]
– one (1) terminal plug connector, 7-pin [for alarm outputs and for the supervised
alarm input]
– three (3) watertight M16 cable glands with O-rings
Installation Manual
Phillips-head screwdriver, M6, for the four (4) captive lid screws (M6 x 35), and for the
M6 mounting screws (if mounting is desired)
Ring crimp tool (Davico type DHCR15 or equivalent)
Four (4) M6 mounting screws and washers (if mounting is desired)
Power cable
Ethernet cable (Cat5e/Cat6e rated to 350 MHz)
Metal conduit suitable for containing cables external to the enclosure
One (1) 2.2K ohm (Ω) end-of-line terminating resistor [for the supervised alarm input, if
desired]
SFP-based fiber optic modules (1GB only) such as:
– Agilent, SFP-GE-SX-MM850-A HFBR5710LP 7
– Cisco, GLC-LH-SM 1300nm
– Cisco, GLC-SX-MM 850nm 8
– Finisar, FTLF8519P2BTL 850nm
Installation Manual
Videojet connect 7000
Bosch Security Systems