Connecting The Emil Expansion Module To The Power; Connecting The Auxiliary Outputs - Bosch NEV 400 LSN Installation Manual

32 en | Cabling
Figure 5.5: Tamper switch connection
5.4 Connecting the EMIL expansion module to
the power supply
For an overview of the cabling, refer to Cabling overview, page
29.
1.
2.
3.
4.
5.
5.5

Connecting the auxiliary outputs

For an overview of the cabling, refer to Cabling overview, page
29.
Connecting AUX 1 (28 VDC)
1.
2.
2019-11 | 04 | F.01U.309.346
Connect two wires to terminal 5 and 6 of the EMIL
expansion module.
Connect the other end of the two wires to the white
terminal block - + of the power supply.
Connect the terminal block with one wire of the prewired
cable supplied with the EMIL expansion module to terminal
35 of the EMIL expansion module.
Connect the terminal block with two wires of the prewired
cable to terminal 31 and 32 of the EMIL expansion module.
Connect the orange terminal block of the prewired cable to
the rightmost position on top of the power supply.
Connect two wires to B and R of the terminal block B of the
power supply
Use the other end of the wires as AUX output 1.
NEV 400 LSN Power
Bosch Security Systems B.V.
supply