Machine's Operation; Controls And Indicators - Telme PRATICA 35W Manual

18 £ng/is/i
Vertical batch freezer
— Remove and disassemble beater:
unscrew knob [16] and pull central hub to remove beater [15]
remove bottom scraper [19] from the beater's blade;
remove the adaptation runners [40] from the center [41];
turn all side scrapers [18] to remove them from beater's blades.
— Remove basin support:
loosen knobs [29];
pull basin support [7] up to remove it.
— Do not remove flap chute as yet.
/ —
29
2B9
7.3 Washing
You must thoroughly wash and sanitize all parts which come into contact with the product to comply with the current norms
in force.
— DO NOT USE:
• NON-FOOD COMPATIBLE cleaning products;
Any SOLVENT (they are poisonous, flammable and can damage the machine's plastic components);
ABRASIVE cleaning products and brushes.
A
A
DO N O T DO THE FOLLOWING OPERATIONS WHEN MACHINE IS ON.
DO NOT ALLOW WATER OR LIQUIDS THROUGH THE SIDE OPENINGS AND THE BACK FAN/
CONDENSER TO PREVENT THE INTERNAL COMPONENTS' (MOTORS, FANS, COMPRESSOR,
ELECTRIC WIRING) GETTING WET.
Extra care should be taken with all AIR condensing system machines, as there are wide condenser
holes on the back panel and wide side holes.
Clean with care all machine's parts which come into contact with the product: inside tub, extraction door and
outlet pipe. Use food-compatible detergents, warm water and /or steam jet:
t
place a container under chute and open extraction door;
wash tub inside;
clean outlet tube and its grill. Use the tube brush supplied and clean from inside the tub;
unscrew knob [26] and remove chute with protection flap [6]. Put all components aside together;
clean extraction door [25];
dry all components.
English
Operating instructions
11
Hote\ do not unnecessarily start the refrigerator
If the rotation is COUNTERCLOCKWISE, the connection to the three-phase electrical supply is wrong, and
must be changed proceeding as follows:
Turn off the device by pressing the ON/OFF Pushbutton [K1 ];
A
TURN THE SOCKET'S BREAKER TO THE "0" POSITION, THEN UN-
PLUG MACHINE;
Open the plug's shell and invert TWO of the THREE conductors connected at the
phases (R-S, R-T or S-T);
Close the plug's shell, plug in the device and repeat the check.
6 MACHINE'S OPERATION
6.1 Warnings
A
WHEN USING THE MACHINE, AS WITH ALL ELECTRICAL DEVICES, ESSENTIAL RULES MUST
BE COMPLIED WITH, PARTICULARLY:
never touch it if your feet or hands are wet;
never operate it while barefoot;
never pull the supply cable to disconnect it from the mains network;
avoid liquids to penetrate in the machine, for example during its cleaning;
forbid children and unable people to operate it.
In case of failure and/or malfunctioning of the machine - and every time you notice damages, mainly at the supply cable or
at the safety devices - turn off the power supply Contact qualified and certified personnel for assistance.
®
NEVER operate the machine in DRY conditions or with an amount of mixture other than the one
recommended.
A
NOT RESPECTING THESE RULES, IN ADDITION TO VOIDING ANY FORM OF WARRANTY, CAN
SERIOUSLY COMPROMISE THE SAFETY, PERFORMANCES AND FUNCTIONING OF THE SAME
MACHINE.
Controls and indicators
All controls and indicators for the use of the device are grouped in a single control
panel placed on the front panel. Its functioning is low-voltage electronically managed.
In this manual, the buttons and indicators are identified with the relative symbol, and/or
with an imprint ([K...] for pushbuttons, [Z...] for indicators).
The functioning of every command is described hereby: to obtain the best results, an
acknowledgment is suggested.
Vi
ON/OFF Pushbutton [K1] - POWER Indicator [Z1]
When the electric supply is connected, the machine is ready to be turned on, the green indicator light [Z1] is on. By
pressing the button, the device turns on and the other buttons are enabled.