6: Preparing The Receiver And The Remote - Sony STR DA6400ES Operating Instructions Manual

6: Preparing the receiver
and the remote
Connecting the AC power cord
(mains lead)
Connect the supplied AC power cord (mains
lead) to the AC IN terminal on the receiver,
then connect the AC power cord (mains lead)
to a wall outlet.
Notes
• Before connecting the AC power cord (mains
lead), make sure that metallic wires of the speaker
cords are not touching each other between the
SPEAKERS terminals.
• Connect the AC power cord (mains lead) firmly.
A several space is left between the plug and the
rear panel even when the power cord (mains
lead) is inserted firmly. The cord is supposed
be connected this way. This is not malfunction.
44
GB
AC IN terminal
To the wall outlet
AC OUTLET
AC power cord
(mains lead)
(supplied)
Notes
• The AC OUTLET(s) on the rear of the receiver is a
switched outlet, which supplies power to the
connected component only while the receiver is
turned on.
• Make sure that the total power consumption of the
component(s) connected to the receiver's AC
OUTLET(s) does not exceed the wattage stated on
the rear panel. Do not connect high-wattage
electrical home appliances such as electric irons,
fans, or TVs to this outlet. This may cause a
malfunction.
Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
POWER
TONE MODE
1
Press POWER to turn off the
receiver.
2
Hold down POWER while
pressing TONE MODE and
HDMI IN to turn on the receiver.
3
Release the TONE MODE and
HDMI IN after a few seconds.
After "MEMORY CLEARING..."
appears on the display for a while,
"MEMORY CLEARED." appears.
All the settings you have changed or
adjusted are reset to the initial settings.
HDMI IN