Table of Contents
Advertisement
Switching the command mode of
the main remote commander
RM SET
UP
SHIFT
1, 2
1
Press ?/1 while pressing RM
SET UP.
The AMP and ZONE buttons flash.
2
Press AMP.
The ZONE button goes off, the AMP
button keeps flashing and the SHIFT
button lights up.
3
Press the numeric button 1 or 2
while the AMP button is
flashing.
When you press 1, the command mode is
set to AV SYSTEM 1. When you press 2,
the command mode is set to AV SYSTEM
2.
The AMP button lights up.
4
Press ENT/MEM.
The AMP button flashes twice, then the
command mode setting process is
completed.
Using a bi-amplifier
connection
?/1
If you are not using surround back speakers,
you can use the SURROUND BACK
SPEAKERS terminals for the front speakers
AMP
for use with a bi-amplifier connection.
ZONE
To connect speakers
ENT/
Front speaker
MEM
(R)
Hi
Lo
Connect the jacks on the Lo (or Hi) side of the
front speakers to the FRONT SPEAKERS A
terminals, and connect the jacks on the Hi (or
Lo) side of the front speakers to the
SURROUND BACK SPEAKERS terminals.
Make sure that metal fittings of Hi/Lo attached
to the speakers have been removed from the
speakers. Not doing so may cause a
malfunction of the receiver.
To set up speakers
1
Press AMP.
The receiver can be operated using the
remote.
2
Press MENU.
The menu is displayed on the TV screen.
Front speaker
(L)
Hi
Lo
continued
109
GB
Advertisement
Table of Contents
