Sony STR DA6400ES Operating Instructions Manual page 19

Name Function
Z Numeric
Press SHIFT (wg), then press to
buttons – preset/tune to preset stations.
– select track numbers of the
CD player, DVD player, Blu-
ray Disc Player or MD deck.
Press -/-- (wj) to select track
number 10.
– select channel numbers of
the VCR or satellite tuner.
– After pressing TV (wf),
press the numeric buttons to
select the TV channels.
wj -/-- Press to
– select track numbers over 10
of the CD player, DVD
player, Blu-ray Disc Player,
or MD deck.
– select channel numbers over
10 of the TV, Satellite tuner
or the VCR.
wk A.F.D. Press to select sound field
(page 79).
wl 2CH/
Press to select sound field or to
A.DIRECT switch the audio of the selected
input to analog signal without
any adjustment (page 78).
e; RESOLUTION Press RESOLUTION
repeatedly to change the
resolution of signals output
from the HDMI OUT or
COMPONENT VIDEO
MONITOR OUT jack.
ea PIP
Press PIP to switch the image of
the PIP (Picture in Picture)
window. The image of the PIP
window is the one from the
EXT VIDEO IN jack. You can
swap the position of the main
screen and the PIP window by
pressing
Note
When the HDMI input is
selected on the main screen, you
cannot swap the position of the
main screen and the PIP window.
es DISPLAY
Press to display the current
status of or information on
components connected to the
receiver.
Note
In the GUI MODE, press the
button to display the menu on
the TV screen.
ed RETURN/
ef CATEGORY
eg DISC SKIP
eh MASTER
ej MUTING
ek BD/DVD/
a)
b)
Notes
(qh). • Some functions explained in this section may not
• The above explanation is intended to serve as an
Name Function
Press to return to the previous
EXIT O menu or exit the menu while the
menu or on-screen guide of the
VCR, DVD player, or satellite
tuner is displayed on the TV
screen.
Press to select the category for
+/–
satellite tuner.
B·/·b Press to select an album.
Press to skip a disc when using
a multi-disc changer.
Press to adjust the volume level
VOL +/– of all speakers at the same time.
TV VOL +/– Press TV (wf), then press TV
VOL +/– to adjust the volume
level of the TV.
Press to turn off the sound
temporarily. Press the button
again to restore the sound.
Press to display the menus of
TOP MENU, the DVD player on the TV
MENU screen. Then use V/v/B/b and
to perform a menu
operations.
MACRO1,
Press AMP (4), then press
MACRO2 MACRO 1 or MACRO 2 to set
up the macro function
(page 141).
See the table on page 135 for information on the
buttons that you can use to control each
component.
The tactile dot is attached to these buttons (TV/5,
N, PRESET +/TV CH +). Use as a mark of
operation.
work depending on the model.
example only. Therefore, depending on the
component, the above operation may not be
possible or may operate differently than described.
continued
19 GB