Sony STR DA6400ES Operating Instructions Manual page 159

6
Press V/v repeatedly to select
the component you want, then
press .
7
Press V/v repeatedly to select
"Learn Mode," then press
8
Press V/v repeatedly to select
the code number you want to
store as the new command,
then press
9
Keep pressing the
corresponding button on the
remote of the component to be
programmed while pointing the
remote towards the receiver's
remote sensor until
"Complete" is displayed on the
TV screen.
Remote sensor
About 5 cm - 10 cm (2" - 4")
"Test" is selected automatically after few
seconds when the registration of a new
code is completed.
10
Press .
The operation test of the programmed
code is started.
Proceed to step 11 if you will not perform
the operation test.
11
Press V/v/B/b repeatedly to
select "Finish."
Note
The display window is turned off while the receiver
is registering the new code.
.
.
To cancel learning
Select "Cancel" on one of the screens
displayed in step 8, 10 and 11, then press
To use a command that has
been learned
1
Press AMP.
The receiver can be operated using the
remote.
2
Press MENU.
The menu is displayed on the TV screen.
3
Press V/v repeatedly to select "Input,"
or b.
then press
4
Press V/v repeatedly to select the
component you want, then press
5
Press QUICK CLICK.
6
Press V/v/B/b to select the button on
the on-screen remote used to learn that
function, then press
.
.
.
159 GB