Table of Contents
Advertisement
21. Loosen two and completely remove one of the
pre-assembled fitter plate screws from the fitter
plate. Connect the single-pin connector from the
fan to the single-pin connector to the light kit -- blue
to black and white to white.
Then, lift the light kit up until the two loosened
fitter plate screws engage the two keyholes in the
light kit. Twist the light kit in a counter clockwise
direction. Then re-install the third fitter plate screw
to secure the light kit to the fitter plate (Fig. 21).
Fitter Plate Screw
22. Install two CFLs in the sockets of the light kit
(Fig. 22).
LAMP CONTAINS MERCURY
Hg
LA BOMBILLA CONTIENE MERCURIO
Manage in accordance with Spills, Disposal and Site Cleanup
Requirements. In case of breakage, follow clean-up
procedures provided by contacts below.
Manipule según las exigencias sobre derrames, eliminación y
limpieza del lugar. En caso se rompa, siga el método de
limpieza proporcionado por los siguientes contactos.
www.epa.gov/c cleanup
1-866-284-4010
23. Attach the glass bowl to the light kit by twisting the
bowl tightly in a clockwise direction until it is secure
(Fig. 23).
Assembly is complete. Turn on the circuit breakers
and the wall switch to the fan supply lead wires.
LIGHT KIT INSTALLATION
13
Fig. 21
Fitter Plate Screw
Fig. 22
Socket
CFL
Fig. 23
Single-pin
Connector
Keyhole
Light Kit
Glass Bowl
Advertisement
Table of Contents
