Light Kit Installation - Honeywell 10288 Manual

23. To install the fan with the light kit:
Remove the three fitter plate screws from fitter
plate. Then connect the 9-pin connectors from the
motor assembly and the light kit. Ensure the plugs
are connected tightly (Fig. 23).
Fitter Plate Screw
24. Align holes in the switch housing with holes in the
fitter plate. Re-insert the three previously removed
fitter plate screws. Use a Phillips screwdriver to
secure all screws (Fig. 24).
Fitter Plate Screw
25. Remove the preassembled rubber washer, hex nut,
finial cap, and finial from the light kit (Fig. 25).

LIGHT KIT INSTALLATION

14
Fig. 23
Fitter Plate
9-pin
Connector
Fig. 24
Fitter Plate
Screw
Fig. 25
Hex Nut
Finial Cap
Fitter Plate
Screw
Switch
Housing
Rubber
Washer
Finial