Download  Print this page

Light Kit Installation; Switch Housing - Honeywell EASTOVER 10214 Owner's Manual

52” ceiling fan
Hide thumbs

Advertisement

14. (Optional) To install the fan without a light kit:
Disconnect the single-pin connectors inside the
switch housing labeled "for light kit connection"
-- black from blue and white from white. Then,
remove the nut and washer located from the
threaded rod in the center of the switch housing to
remove the light kit and wiring (Fig. 14A).
Nut
Washer
Remove the screws from the fitter plate. Align
holes in switch housing with holes in upper switch
housing. Reinstall screws that were previously
removed. Use a Phillips screwdriver (not included)
to secure all screws. Plug the hole in the switch
housing with the plastic cap (Fig. 14B). Proceed to
step 20.
Plastic Cap
Screw
15. To install the fan with light kit:
Remove screws from the fitter plate. Then connect
the plug from the motor assembly to the plug from
the light kit, matching the colors on each plug.
Ensure that the plugs connect tightly (Fig. 15).
Screw

LIGHT KIT INSTALLATION

10
Hex Nut
Fig. 14A
Washer
Switch
Housing
Light Kit
Fig. 14B
Switch
Housing
Plastic Cap
Fig. 15
Plug
Switch
Housing
Screw
Screw

Advertisement

Table of Contents
loading

  Related Manuals for Honeywell EASTOVER 10214