Maintenance And Repair; General Information; Cleaning; Routine Tasks - Walther Systemtechnik VMS-08 Assembly Instructions Manual

Mini-full-jet valve
Table of Contents

Advertisement

Rev. 1.1

8 Maintenance and Repair

8.1 General Information

CAUTION
Before starting any maintenance or repair work, ensure that all air-operated tools are
depressurized and disconnected from the air supply.
Before opening the spray valve it must be disconnected from the air and fluid supply.
Otherwise, ejected components can cause injuries.
The full jet valves of the VMS-08 series are high precision tools. Always keep clean and observe minimum
instructions to maintain a long and useful life of valve. We recommend lubricating moveable parts regularly,
and greasing threads, especially the nozzle threads, when replacing or cleaning the nozzle. It is
recommended to use clean and filtered application fluid only. The control air should also be clean and slightly
oiled. Individual operating conditions and differing media require a minimum and regular routine care.

8.2 Cleaning

Wash equipment thoroughly after use to remove residues and dirt, especially if needle (pos.5), needle gasket
(pos.4.2) or nozzle (pos.1) is to be exchanged.
IMPORTANT
Only use soft brushes for outside cleaning of the nozzle tips. Never use metal tools
with sharp edges!
IMPORTANT
Do not start any repair work on the installed device. Remove the device from the ma-
chines first. (Disconnect from the air and fluid supply!)

8.3 Routine Tasks

No.
Description
Connecting lines
1.
(tightness)
2.
Luer-Lock

8.4 Spare Parts

IMPORTANT
Only use original spare parts from the manufacturer!
Wrong or defective spare parts from other manufacturers can damage the device. If
other than original spare parts of the manufacturer will be used, all obligations from the
manufacturer or his sales partners, such as guarantees, service contracts etc will be
forfeited without further notice.
Assembly Instructions - MINI-Full-Jet Valve VMS-08
Cleaning
Lubricating
X
Inspecting
Additional
X
Replace when
X
damaged
Walther Systemtechnik GmbH – D 76726 Germersheim
Telefon: +49 (0)7274-7022-0 Telefax: +49 (0)7274-7022-91
http://www.walther-2000.de – info@walther-2000.de
Page 11 of 16
Frequency
Monthly
Monthly

Advertisement

Table of Contents
loading

Table of Contents