Table of Contents
Advertisement
6. SETTING THE IMPLEMENT
6.1 Attaching the Implement
It is important to place the machine on flat ground. Always use extreme caution when
reversing the tractor toward the machine.
1. Check that the height from the ground of the drawbar hitch (1) and of the tractor hitch (6) are suitable for
having the drawbar (A) parallel to the ground when it is hitched to the tractor. To adjust the drawbar, carry
out operations (2) and (3).
2. Remove the pins (2) from the hitch (1), removing the washers (3) and bolts (4).
3. Set the hitch (1) in the desired position, moving it to the free holes (5), and fasten with the pins, bolts and
washers used previously. The hitch can be rotated from position (E) to position (F) to obtain the best
position.
4. Connect the drawbar hitch (1) to the tractor hitch (6) with pins (7) or (8) depending on size needed.
5. Remove the parking stand (() from point (B), removing the clip (11) and the pin (10).
6. Move it to point (C), securing it in place with the pin (10) and the clip (11).
7. Check that the drawbar (A) is parallel to the ground.
Check the functionality of the machine, remembering that this must be done in a suitable area and with no
bystanders within the operating range of the machine.
Before carrying out any maintenance, adjustments or repairs on the machine, switch off the
tractor engine, remove ignition key, wait until all moving parts have come to a standstill.
XLRRX 06/18
© 2018 Alamo Group Inc.
OPERATION
Operation Section 4-8
Advertisement
Table of Contents
