Advertisement

Quick Links

Published 08/20
This Operator's Manual is an integral part of the safe operation of this machine and must
be maintained with the unit at all times. READ, UNDERSTAND, and FOLLOW the Safety
and Operation Instructions contained in this manual before operating the equipment. C01-
Cover
®
BUSH HOG
2501 Griffin Ave.
Selma, AL 36703
334-874-2700
www.bushhog.com
© 2020 Alamo Group Inc.
OPERATOR'S MANUAL
AGR
BGR
BRGR
SERIES GRAPPLES
Part No. 50075567
$0.00

Advertisement

Table of Contents
loading

Summary of Contents for Alamo Bush Hog AGR Series

  • Page 1 READ, UNDERSTAND, and FOLLOW the Safety and Operation Instructions contained in this manual before operating the equipment. C01- Cover ® BUSH HOG 2501 Griffin Ave. Selma, AL 36703 334-874-2700 www.bushhog.com © 2020 Alamo Group Inc. $0.00...
  • Page 2 To the Owner/Operator/Dealer All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded operator who recognizes the potential hazards and follows reasonable safety practices. The manufacturer has designed this implement to be used with all its safety equipment properly attached to minimize the chance of accidents.
  • Page 3: Table Of Contents

    TABLE OF CONTENTS SAFETY SECTION ......................1-1 General Safety Instructions and Practices ......................1-2 Operator Safety Instructions and Practices ....................... 1-4 Equipment Operation Safety Instructions and Practices ..................1-5 Connecting or Disconnecting Implement Safety Instructions and Practices ............ 1-11 Maintenance and Service Safety Instructions and Practices ................1-11 Storage and Parking Safety Instructions and Practices ...................
  • Page 5: Safety Section

    SAFETY SECTION AGR-BGR-BRGR 08/20 Safety Section 1-1...
  • Page 6: General Safety Instructions And Practices

    Safety Messages. Always use good common sense to avoid hazards. (SG-2) Si no lee ingles, pida ayuda a alguien que si lo lea para que le traduzca las medidas de seguridad. (SG-3) AGR-BGR-BRGR 08/20 Safety Section 1-2 © 2020 Alamo Group Inc.
  • Page 7 Push and pull the control levers in and out several times to remove pressure. Do not work under raised Boom or Bucket unless components are securely blocked up to prevent inadvertent dropping. (SBH-7) AGR-BGR-BRGR 08/20 Safety Section 1-3 © 2020 Alamo Group Inc.
  • Page 8: Operator Safety Instructions And Practices

    Take scheduled work breaks to help prevent these potentially impaired operating conditions. Never operate the Implement and Tractor in a fatigued or bored mental state which impairs proper and safe operation. (SG-32) AGR-BGR-BRGR 08/20 Safety Section 1-4 © 2020 Alamo Group Inc.
  • Page 9: Equipment Operation Safety Instructions And Practices

    Serious injury could result from a structural failure when the Boom is used for purposes other than those for which it was designed. (SBH-9) AGR-BGR-BRGR 08/20 Safety Section 1-5 © 2020 Alamo Group Inc.
  • Page 10 Keep bystanders 10 feet away from the tractor and loader while operating. The bystanders could enter the path of the tractor or items could fall from the loader resulting in serious injury to the bystander. (SL-01) AGR-BGR-BRGR 08/20 Safety Section 1-6 © 2020 Alamo Group Inc.
  • Page 11 Always wear your seatbelt and make sure the ROPS structure is fully deployed to prevent serious injury or death from the tractor tipping over. (SL-11) AGR-BGR-BRGR 08/20 Safety Section 1-7 © 2020 Alamo Group Inc.
  • Page 12 Do not operate the loader from the ground. Operate the tractor and loader only while seated in the tractor seat with the seatbelt fastened. The loader could fall crushing a person resulting in serious injury or death. (SL-16) AGR-BGR-BRGR 08/20 Safety Section 1-8 © 2020 Alamo Group Inc.
  • Page 13 Turn curves or go up slopes only at low speed and using a gradual turning angle. Go up slopes with the Implement located uphill. Slow down on rough or uneven surfaces. (SPU-2) AGR-BGR-BRGR 08/20 Safety Section 1-9 © 2020 Alamo Group Inc.
  • Page 14 Sudden or unexpected movement or dropping of the loader and attachment could result in serious injury. (SL-32) AGR-BGR-BRGR 08/20 Safety Section 1-10 © 2020 Alamo Group Inc.
  • Page 15: Connecting Or Disconnecting Implement Safety Instructions And Practices

    (SG-5) Do not modify or alter this Implement. Do not permit anyone to modify or alter this Implement, any of its components or any Implement function. (SG-8) AGR-BGR-BRGR 08/20 Safety Section 1-11 © 2020 Alamo Group Inc.
  • Page 16 Be alert to worn component surfaces which have sharp edges. Sharp surfaces can inflict severe laceration injuries if proper hand protection is not worn. (SG-37) Cancer and Reproductive Harm www.P65Warnings.ca.gov AGR-BGR-BRGR 08/20 Safety Section 1-12 © 2020 Alamo Group Inc.
  • Page 17: Storage And Parking Safety Instructions And Practices

    Safety Messages and operation instruction in each of the appropriate sections of the Tractor and Equipment Manuals. Pay close attention to the Safety Signs affixed to the Tractor and Equipment. (SG-18) AGR-BGR-BRGR 08/20 Safety Section 1-13 © 2020 Alamo Group Inc.
  • Page 18: Decal Location

    (Some shipping and handling charges may apply). Contact your Bush Hog dealer to order replacement decals. AGR-BGR-BRGR 08/20 Safety Section 1-14 © 2020 Alamo Group Inc.
  • Page 19: Introduction Section

    INTRODUCTION SECTION Introduction Section 2-1...
  • Page 20 Indicates an imminently hazardous situation that, if not avoided, MAY result in MINOR INJURY. Identifies special instructions or procedures that, if not strictly observed, could result in damage to, or destruction of the machine, attachments or the environment. AGR-BGR-BRGR 08/20 Introduction Section 2-2 © 2020 Alamo Group Inc.
  • Page 21 Bush Hog attachments will save you time and money and handle all jobs with ease. Front and rear, and left and right are determined by the normal direction of travel (the same as on your automobile). AGR-BGR-BRGR 08/20 Introduction Section 2-3 © 2020 Alamo Group Inc.
  • Page 23: Assembly Section

    ASSEMBLY SECTION Assembly Section 3-1...
  • Page 24: Assembly

    Light weight tractors and some skid steer loaders will require rear ballast for heavy loads to maintain steering control. Be sure to consult your Skid Steer or Tractor Operator’s Manual to determine whether or not to add ballast. AGR-BGR-BRGR 08/20 Assembly Section 3-2 © 2020 Alamo Group Inc.
  • Page 25: Operation Section

    OPERATION SECTION Operation Section 4-1...
  • Page 26 7 FT Useable 28” 28” Useable Open Height 46-1/2” 46-1/2” Useable Width 71” 83” (Inside Side Plates) Roll Back Angle 13º 13º Weight 702 Lbs. 787 Lbs. Number of Teeth AGR-BGR-BRGR 08/20 Operation Section 4-2 © 2020 Alamo Group Inc.
  • Page 27 5 Ft (Inside Side Plates) 6 Ft Weight 372 (5 Ft.) 409 (6 Ft.) Number of Teeth 5 (5 Ft.) 5 (6 Ft.) Paint Options R, G, O, B, or Y AGR-BGR-BRGR 08/20 Operation Section 4-3 © 2020 Alamo Group Inc.
  • Page 28: Operator Requirements

    A crushing hazard exists when hooking-up attachments. DO NOT allow anyone to stand between the Skid Steer/Tractor and the attachment itself. DO NOT operate hydraulic controls while someone is near the Skid Steer/Tractor or attachment. AGR-BGR-BRGR 08/20 Operation Section 4-4 © 2020 Alamo Group Inc.
  • Page 29: Hook-Up With Skid Steer Style Hitch

    2. Lock the upper attachment bar into the upper hooks. 3. Lift the loader up and tilt back until the lower attachment pins can be secure to the loader with lynch pins. AGR-BGR-BRGR 08/20 Operation Section 4-5 © 2020 Alamo Group Inc.
  • Page 30 20-30 feet to ensure the attachment does not disconnect. If the attachment disconnects during this process, discontinue the use of the attachment and contact your dealer. AGR-BGR-BRGR 08/20 Operation Section 4-6 © 2020 Alamo Group Inc.
  • Page 31: Hydraulic Hose Hook-Up

    12. Position load at a safe, low traveling height before transferring to the unloading site. AGR-BGR-BRGR 08/20 Operation Section 4-7 © 2020 Alamo Group Inc.
  • Page 32: Releasing A Load

    8. Leave enough clearance when turning and/or lowering the Grapple so that it does not make contact with obstacles such as vehicles, buildings trees, or fences. 9. Lower Grapple to transporting height (low to the ground) before moving again. AGR-BGR-BRGR 08/20 Operation Section 4-8 © 2020 Alamo Group Inc.
  • Page 33: Break Sod With Lower Jaw

    6. Store Grapple on a level surface in a clean, dry place. Inside storage will reduce maintenance and make for a longer Grapple life. 7. Do not allow children to play on or around the stored Grapple. AGR-BGR-BRGR 08/20 Operation Section 4-9 © 2020 Alamo Group Inc.
  • Page 34: Troubleshooting Guide

    Never run teeth under ground object below ground such as tree to get under a load. roots and rocks. Wedging objects between the Do not wedge objects between the teeth. teeth. AGR-BGR-BRGR 08/20 Operation Section 4-10 © 2020 Alamo Group Inc.
  • Page 35: Maintenance Section

    MAINTENANCE SECTION Maintenance Section 5-1...
  • Page 36: Proper Torque For Fasteners

    NOTE: These values apply to fasteners as received from supplier, dry or when lubricated with normal engine oil. They do not apply if special graphited or molydisulphide greases or other extreme pressure lubricants are used. This applies to both UNF fine and UNC coarse threads. AGR-BGR-BRGR 08/20 Maintenance Section 5-2 © 2020 Alamo Group Inc.
  • Page 37 TO THE OWNER/OPERATOR/DEALER To keep your implement running efficiently and safely, read your manual thoroughly and follow these directions and the Safety Messages in this Manual. The Table of Contents clearly identifies each section where you can easily find the information you need. The OCCUPATIONAL SAFETY AND HEALTH ACT (1928.51 Subpart C) makes these minimum safety...
  • Page 38 AGR, BGR, BRGR GRAPPLE AGR, BGR, BRGR-SOM-08/20 P/N 50075567 Printed U.S.A...

Table of Contents