Table of Contents
Advertisement
Secure the Implement for transport before traveling on public roads.
Implements, secure the center axle using cylinder stops or transport pin and properly attach
a safety chain between the Implement and Tractor. Secure wings in upright position on
folding Implements using wing transport locks.
Always keep a careful lookout and use extreme care when working
around overhead obstructions and electrical power lines.
Implement wing can be over 10 feet high.
wing to come within 10 feet of any power line.
Your driving vision may be reduced or impaired by the tractor, cab, or implement. Before
driving on public roadways identify any limited vision areas, and make adjustments to your
operating position, mirrors, and the implement transport position so that you can clearly
see the area where you will be traveling, and any traffic that may approach you. Failure to
maintain adequate vision of the public roadway and traffic can result in serious injury or
even death.
Maintenance and Service Safety Instructions and Practices
Relieve hydraulic pressure prior to doing any maintenance or repair work
on the Implement.
blocked up, disengage the PTO, and turn off the tractor engine. Push
and pull the Remote Cylinder lever in and out several times prior to
starting any maintenance or repair work.
Keep fingers clear of adjusting holes. A sudden movement could cause injury or even
amputate fingers. KEEP CHILDREN AWAY WHEN MAKING ADJUSTMENTS.
Always maintain the safety signs in good readable condition. If the safety signs are missing,
damaged, or unreadable, obtain and install replacement safety signs immediately.
Do not modify or alter this Implement.
Implement, any of its components or any Implement function.
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
XLRRX 06/18
© 2018 Alamo Group Inc.
SAFETY
(STI-10)
Place the Implement on the ground or securely
(SG-14)
Safety Section 1-10
(STI-7)
Never allow the Implement
(STI-8)
(S3PT-09)
Do not permit anyone to modify or alter this
(SG-8)
For pull-type
The
(SBL-3)
(SG-5)
Advertisement
Table of Contents
