Table of Contents
Advertisement
OPERATION
6.2 Setting Working Width
The hydraulic cylinders (B) and (D) in Ops-2384
make it possible to rapidly adjust the working width
and windrow width from the tractor valve using the
electric selector as shown in Ops-2385. (Angulation
and Extension)
To change the extension of the telescoping arm (A),
move the tractor valve connected to the line of
hoses of cylinders (B), after having selected the
"EXTENSION" position on the remote control.
To change the angle of the arm (C) move the tractor
valve connected to the line of hoses of cylinders
(D), after having selected the "ANGULATION"
position on the remote control.
NOTE: Changing the working angle results in the
changing of the windrow width.
NOTE: If the hydraulic movements on the right and
left sides of the machine get slightly out of sync with
each other, do a complete cycle of opening and
closing over the entire stroke of the cylinders in
question
to
restore
the
symmetry
of
the
movements.
.
6.3 Fuse and Electrical
The fuse is located on one side of the control box
and can be accessed by unscrewing the protective
cap.
The cable for the solenoid valve has a connector
with an LED light that turns on when current is
passing through.
NOTE: Before replacing the fuse, check with expert
personnel to ensure that there are no short circuit
contacts in the electrical circuit. Ops-2387
XLRRX 06/18
Operation Section 4-9
© 2018 Alamo Group Inc.
Advertisement
Table of Contents
