Rear Center Rake Wheel Kit Hydraulic System Assembly - Alamo BUSH HOG XLRRX Series Operator's Manual

8. Fasten the rake RH wheel (30) to the LH arm (31) using six bolts (34), with washers and nuts.
9. Fasten the rake LH wheel (32) to the RH arm (33) using six bolts (34) M10 x 25 (25/64" x 1") DIN 933, split
washer ø10.5 (ø26/64") DIN 127B and nut M10 (25/64") DIN 934.

REAR CENTER RAKE WHEEL KIT HYDRAULIC SYSTEM ASSEMBLY

Before proceeding, make sure that the hydraulic system is not under pressure. Wear
personal protective equipment (gloves, goggles, etc.). When loosening the fittings,
proceed with care and caution.
1. Remove the T fittings and replace them with cross fittings (10).
2. Connect the hose (9) from the 3/8" female fitting side to the boss of the cylinder using fitting (13), banjo
(14), tow washers (1) and throttling nipple (8). Do not fully tighten at this stage.
3. Connect the 1/4" female side (11) of the hose (9) to the T fitting (10). Correctly position hose (9) so that it
does not get deformed or crushed when the cylinder is operating. Once this is done, tighten all the various
components that had been left untightened earlier.
XLRRX 06/18
© 2018 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-22