Table of Contents
Advertisement
The tractor used to operate the implement must have the power capacity to lift, pull, and operate the Power
Take Off (PTO) at the implement's rated speed while traveling at a ground speed between 2 and 5 MPH.
Operating the implement with a tractor that does not meet the following requirements may cause tractor or
implement damage and be a potential danger to the operator and passersby.
Tractor Requirements and Capabilities
•
ASABE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.
•
Tractor Safety Devices ..................... Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield
•
Tractor Horsepower-Minimum .......... XLRRX1226 - 50HP, XLRRX1428 - 60HP
2.1 ROPS and Seat Belt
The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat
belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be
crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.
Tractor models not equipped with a ROPS and seat belt should have these life saving features installed by an
authorized dealer. OPS-U- 0003
Operate this Equipment only with a Tractor equipped with an approved roll-
over-protective system (ROPS). Always wear seat belts. Serious injury or
even death could result from falling off the tractor--particularly during a turnover
when the operator could be pinned under the ROPS.
2.2 Tractor Safety Devices
If transporting or operating the tractor and implement near a public roadway, the tractor must be equipped with
proper warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of
the unit. Lights and a SMV emblem must be equipped directly on implements if the visibility of the tractor
warning signals are obscured.
Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were
removed for access to connect, service, or repair the tractor or implement.
with the PTO master shield missing or in the raised position. OPS-U- 0004
2.3 Tractor Horsepower
The horsepower required to operate the rake depends on many factors including type of vegetation to be
raked, terrain condition, operator experience, and condition of the implement and tractor. For most raking
condition, the XLRRX1226 rakes require a tractor with at least 50 HP and the XLRRX1428 60HP. Operating
the implement with a tractor that does not have adequate power may damage the tractor engine.
3. GETTING ON AND OFF THE TRACTOR
Before getting onto the tractor, the operator must read and completely understand the implement and tractor
operator manuals. If any part of either manual is not completely understood, consult an authorized dealer for
a complete explanation. OPS-U- 0007
XLRRX 06/18
© 2018 Alamo Group Inc.
OPERATION
Operation Section 4-5
(SG-7)
Never operate the tractor PTO
Advertisement
Table of Contents
