Table of Contents
Advertisement
6.5 Adjusting Rake Ground Pressure
The pressure of the rake wheels against the ground
can be adjusted with the spring (1).
- Lower the rake arms, using the hydraulic lever on
the tractor.
- Adjust the rake wheel pressure by turning the
adjustment nut (B), using a 36mm wrench "A" (not
included).
- Compressing the spring (1) reduces the pressure
against the ground.
- Loosening the spring (1) increases the pressure
against the ground.
The rake wheels are driven by their contact with the ground. Adjust the wheel ground pressure for good raking
action without damaging the crop. Too little ground pressure will allow rake wheels to slip over hay. Too much
ground pressure will cause dirt or rocks to be mixed into the hay and will cause premature wear of the finger
wheels.
Ground speed affects raking performance. Be sure to operate the rake at recommended raking ground speeds
when checking ground pressure.
7. PRE-OPERATION INSPECTION AND SERVICE
Before each use, a pre-operation inspection and service of the implement and tractor must be performed.
This includes routine maintenance and scheduled lubrication, inspecting that all safety devices are equipped
and functional, and performing needed repairs. DO NOT operate the unit if the pre-operation inspection
reveals any condition affecting safe operation. Perform repairs and replacement of damaged and missing
parts as soon as noticed. By performing a thorough pre-operation inspection and service, valuable down time
and repair cost can be avoided. OPS-U-0029
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
Periodically inspect all moving parts for wear and replace when
necessary with authorized service parts. Look for loose fasteners, worn
or broken parts, and leaky or loose fittings. Make sure all pins have
cotter pins and washers. Serious injury may occur from not maintaining
this machine in good working order.
XLRRX 06/18
© 2018 Alamo Group Inc.
OPERATION
(SG-14)
(SG-21)
Operation Section 4-11
Advertisement
Table of Contents
