Treadbelt Tracking - Landice 90 Series Installation Manual

Installation
2.8.

Treadbelt Tracking

1. Ensure that the Treadbelt tracks properly. Treadbelt tracking is
maintained by ensuring that the drive and take-up rollers are
parallel, each is at right angles to the frame, so that the treadbelt
tension from side to side is equal as shown in the following figure. If
the treadbelt is running diagonally, with unequal gaps between the
treadbelt and sides then the rollers must be adjusted (see Figure 2-
30).
Figure 2-30. Tracking Setup
Treadbelt to side gap.
Check both sides,
front and rear.
Front,
drive
roller
Belt tension, right side
Belt
running
true due
to equal
Belt tension, left side
belt
tension.
Adjustment is performed using the two adjustment screws (6mm
Allen wrench) located at rear of treadmill, see Figure 2-30. The
following provides a tracking adjustment example: Treadbelt tracks
to the right:
26
90°
90° 90°
Belt tension equal
on both sides
Treadbelt Tracking
90°
90° <90°
Belt tension, right side
Belt tension
greater on left
side
Belt tension, left side
Rear, take-
up roller
Belt forced to
the right side,
belt running
diagonally,
gaps unequal
from front to
rear.