Treadbelt Tracking Adjustment - Landice 90 Series Owner's Manual

4. Plug treadmill in, turn power switch on, start treadmill at 0.5
mph, gradually increase speed to 3.0 mph and verify
tracking is correct. Slight adjustments may be required.
Walk on treadmill for approximately 5 minutes to ensure
lubricant is evenly spread throughout inner belt surface.
5. Slipcoat is used exclusively for treadbelt maintenance and
should not be used on any other surface. In the event
Slipcoat lubricant spills onto outer treadbelt surface or
surrounding areas, clean residue using rubbing alcohol on
a clean rag or sponge.

7.2.2. Treadbelt Tracking Adjustment

The treadbelt is designed to move to the left and to the right as
it spins, this allows the treadbelt to accommodate different
walking patterns. The only time the treadbelt needs to be
adjusted is if it is contacting stationary components. The
treadbelt will drift with use and should not be adjusted simply to
achieve "perfect" centering on the roller. If adjustment is
necessary please make sure the treadmill is level prior to
making any adjustments. To ensure proper belt tracking and
alignment, the treadmill must be placed on a stable and level
surface. Use a carpenter's level to verify treadmill base is level
left to right. Adjust rear feet to obtain level surface prior to any
adjustments.
The treadbelt is tracked by means of the two 9/16" hex head
bolts at the rear of the treadmill. Tightening (clockwise) the bolt
on the side of the treadmill that the belt has moved towards and
loosening the bolt on the opposite side an equal amount, will
cause the belt to move toward the center. Adjustments should
be made in ¼-turn increments, with the treadmill running at
2 to 3 mph. Allow at least 30 seconds for the belt to stabilize
between each adjustment.
Maintenance and Troubleshooting
95