YASKAWA FSDrive-MV1000 Series Instructions Manual page 44

2.2 Mechanical Installation
When using rollers to move the drive panel, make sure that the following conditions are met. Improper handling could
result in damage to the drive.
• Place the panel on the rollers while adjusting their positions so that they extend approximately 100 mm each side of the
panel's frame.
• Distribute the weight of the drive evenly on the rollers so stress is evenly distributed on the bottom of the drive.
• Create a smooth, even surface for rolling by laying boards flat on the floor. Use boards with sufficient strength and
durability, and make sure the boards do not have gaps between them.
1. Attach the wire ropes for lifting to the support hooks on the top of the panel to lift the drive.
Figure 2.2
2. Ensure that the hanging angle is no greater than 60
44
Table 2.4 Transportation Procedure 1 (Class: 2 kV)
Transportation Procedure
Wire ropes for lifting
Top view
Drive
Figure 2.2 Inserting Wire Ropes for Lifting
Front view
.
°
YASKAWA ELECTRIC EZZ010926 FSDrive-MV1000 Instructions
Hanging angle of 60° max.