Table of Contents
Advertisement
5 - Operation
Filling the clean water tank
The clean water tank is located at the front and integrated in the main
tank design. It is used for washing hands, gloves and cleaning clogged
nozzles, etc.
WARNING! Although this tank is completely separate from the
main tank and should only be fi lled with clean water, this does
not mean that the water is suitable for drinking.
Drain valve
The valve for safe draining is located on the underneath of the tank. To
access it, you must crouch on the left side of the equipment, where the
jockey wheel is attached to the chassis when the equipment is hitched
to the tractor.
To empty the tank, pull the handle towards the valve. To fi ll the tank
again, pull the valve handle toward the front of the equipment and it
will close.
WARNING! When opening the valve, take care to ensure that the
liquid does not spill over your hands or feet.
To empty the residual liquid in a special tank or container for storage, the
quick release A of the drain valve can be adapted to connect a hose with
the fi tting B so that liquid can be emptied safely.
Manifold system
A & C is spraying position
B & C is TurboFiller position
D & E is Rinsing position
F is step less agitation. 3 is Max , 0 is closed
G is 15 bar safety valve; it is important to open it once in a while,
especially under cleaning process, to avoid chemical residues in the
tubes connected.
62
A
B
F
D
C
A
G
E
B
Advertisement
Table of Contents
