Sampling Procedures - Quincy QGB Series Instruction Manual

Belt drive air compressors

Hide thumbs

Table Of Contents

100

Table of Contents

Preferred sample location is the fluid filter. If unable to take sample from fluid filter, proceed as

follows:

. Shutdown and lockout compressor.

2. Relieve pressure in reservoir.

3. Remove plug from reservoir drain line.

4. Drain water from reservoir and discard in approved manner.

5. Fill sample bottle with fluid.

6. Close valve and replace plug in drain line.

7. Return compressor to service and check fluid level during operation. Service with fluid as

required.

Using fluid filter sample valve, proceed as follows:

. Open valve, drain 2-4 ounces of fluid from filter and discard in an approved manner.

2. Fill sample bottle.

3. Close valve.

After collecting sample from either of the above methods:

. Fill out information label completely.*

Be certain to provide all information as to possible hazards related to a given sample. If this situation

exists, all information shall be clearly marked on the sample bottle label.

2. Attach Sample Bottle Label to the bottle and put bottle in mailer.

3. Place Shipping Label on the outside of the mailer and send it by UPS.

FROM:__________________________________________

Customer_Fax_#____________________________________

Model_No._ _ ____________ _Serial_No.__________________

Fluid___________________ Sample_Date_ _ ______________

Hours_on_Fluid__________ Hours_on_Machine___________

Distributor_ _ _______________________________________

Sample_From______o__Reservoir______o__Filter

Sample Bottle Label

Note: A fluid sample valve kit is available from Quincy Compressor. Contact the Service

Department and ask for part number 43286.

Section VII - Compressor Fluids