Sampling Procedures - Quincy QSI-90 Instruction Manual

Direct drive air compressors

Hide thumbs

Table Of Contents

Table of Contents

Preferred sample location is the ﬂ uid ﬁ lter. If unable to take sample from ﬂ uid ﬁ lter, proceed as

follows:

1. Shutdown and lockout compressor.

2. Relieve pressure in reservoir.

3. Remove plug from reservoir drain line.

4. Drain water from reservoir and discard in approved manner.

5. Fill sample bottle with ﬂ uid.

6. Close valve and replace plug in drain line.

7. Return compressor to service and check ﬂ uid level during operation. Service with ﬂ uid as

required.

Using ﬂ uid ﬁ lter sample valve, proceed as follows:

1. Open valve, drain 2-4 ounces of ﬂ uid from ﬁ lter and discard in an approved manner.

2. Fill sample bottle.

3. Close valve.

After collecting sample from either of the above methods:

1. Fill out information label completely.*

Be certain to provide all information as to possible hazards related to a given sample. If this situation

exists, all information shall be clearly marked on the sample bottle label.

2. Attach Sample Bottle Label to the bottle and put bottle in mailer.

3. Place Shipping Label on the outside of the mailer and send it by UPS.

FROM: ________________________________________

Customer Fax # ___________________________________

Model No._____________ Serial No. _________________

Fluid __________________ Sample Date_______________

Hours on Fluid _________ Hours on Machine __________

Distributor________________________________________

Sample From

Sample Bottle Label

Note: A ﬂ uid sample valve kit is available from Quincy Compressor. Contact the Service

Department and ask for part number 143286.