Power On And Off; Standby And Ready - R&S EB500 Getting Started

®
R&S EB500
1.2.6

Power On and Off

The DC power connection X1 is located at the top left corner of the
R&S EB500 rear panel. With the DC power connected, the
R&S EB500 is in STANDBY or READY state, depending on the state
of the STANDBY toggle switch at the front panel of the R&S EB500
when it was last switched off. The standby power is below 0.8 W.
1.2.7

STANDBY and READY

The STANDBY key is located at the bottom left corner of the front
panel. With the DC power connected, press the STANDBY key
briefly to switch the R&S EB500 from the STANDBY to the READY
state and vice versa. In STANDBY state, the amber LED on the right
will turn on and only the power switch circuit is being powered. In this state, it is safe
to remove the DC power and disconnect the R&S EB500 from the AC/DC power
adapter. In READY state, the green LED on the left is on. The R&S EB500 is ready
for operation. All modules are being powered and the R&S EB500 initiates its startup
procedure.
EB500 without front control panel
In the case of EB500 without front control panel, the green Power LED dou-
bles as a 'Fail' status LED. In conditions of failure, the LED will turn red instead
of green, as shown in the figures below.
EB500 without front control panel Ready
Getting Started 4072.8432.02 ─ 04
EB500 without front control panel in Failure
mode. Refer to the Troubleshooting section in
the Operating Manual for possible actions to
take.
Preparation for Use
Setup
10