Changing The Ip Address; Using Update32 Tool - R&S EB500 Getting Started

®
R&S EB500
4.5

Changing the IP Address

4.5.1

Using Update32 Tool

The IP address of the R&S EB500 can be changed using the "Update32" tool. By
default, the R&S EB500 is shipped with DHCP enabled.
Refer to "Retrieve Update32" under ​
EB500 without front control
running the "Update32" tool.
Starting the procedure
Run Update32 and allow access if there are security warnings. If a configuration
is not loaded previously, refer to "Selecting the configuration file" under ​
the configuration file"
"Config" -> "LAN Settings via Ethernet" as shown below:
Selecting the target R&S EB500
The R&S EB500, for which you want to update the IP address, needs to be switched
on. Make sure there is a LAN connection between the R&S EB500 and the PC. After
a short period, a new entry will be shown in the list of targets as shown in ​
ure 4-2. Select the appropriate target and press the "Start" button.
Changing the IP address
Make the desired changes in the LAN settings dialog as shown below. Select
"DHCP" if the R&S EB500 is to be connected to a DHCP server.
Getting Started 4072.8432.02 ─ 04
c hapter 4.3, "Receiver Firmware Update for
panel", on page 56 to read the steps for retrieving and
on page 59 to select an appropriate configuration file. Select
Software and Firmware Update
Changing the IP Address
" Selecting
f ig-
68