Receiver Firmware Update For Eb500 Without Front Control Panel - R&S EB500 Getting Started

®
R&S EB500
Remote GUI on Notebook / desktop PC
If you want to install the GUI for use on a notebook or desktop PC, you should
follow the procedure described in ​
Access", on page 63.
If the R&S EB500 cannot reboot
Due to the fact that the R&S EB500 also can be updated using the Update32
Tool (see ​
" Updating the EB500 with front control panel"
is a chance that the R&S EB500 cannot reboot. Follow the steps described
in ​
" If the R&S EB500 cannot reboot"
4.3 Receiver Firmware Update for EB500 without
front control panel
This model requires a different update method which makes use of the LAN inter-
face of the R&S EB500 (X7 on the rear panel). The method uses the "Update32"
tool, which runs under Windows NT, Windows 2000 and Windows XP.
Retrieve Update32
The firmware required for the update can be retrieved from either one of the loca-
tions mentioned at ​
Click on Firmware Update Program and File Explorer will be launched into
the directory Update32XP. The Update32 tool can be installed by clicking on
Setup. If your browser does not launch File Explorer, you should launch it
manually and navigate to the Update32XP directory on the CD-ROM where you
can run Setup.
Getting Started 4072.8432.02 ─ 04

Receiver Firmware Update for EB500 without front control panel

" CD-ROM and Downloads"
Software and Firmware Update
c hapter 4.4, "GUI Installation for Remote
on page 63 to deal with this problem.
on page 48.
on page 63), there
56