YASKAWA V1000 Basic User's Manual page 4

To Access & Change Paramaters
With the VFD powered on and the motor not running;
1. Press the or
button, display will now show Parameter A1-02 with the "A" flashing
2. Press the
ENTER
3. Press the or
4.
You will now see the current setting for the selected parameter, left digit will flashing
5.
Press the or
6. You will now see the next parameter with the left digit flashing
7. If you want to adjust more parameters, go to step 3.
8. If you are done, press
9.
Press the or
Document Title: Tech Guide ~ Yaskawa V1000 Basic User Guide
Document Revision: v1.0.5
18805 Adams Ct., #110 ~ Morgan Hill, CA 95037, USA ~ +1-408.924.0808 ~ www.washlinksystems.com ~ support@washlinksystems.com
Display
Standard Operator Panel
button until the screen showes
or to get to the parameter you want to adjust, then press
RESET
or to change the parameter, then press
RESET
until you get back to the
ESC
button until the screen shows
Parameter Setting mode.
ENTER
screen
(motor speed in Hz).
page 4
ENTER
of 10