YASKAWA V1000 Basic User's Manual page 3

To Change Display Data View
The standard screen after a power cycle is the actual output in Hz (xx.xx)
To change data being displayed, press the
Output Frequency (Hz)
Output Current (Amps)
Output Voltage
Monitor Display (typically not used)
Verify Menu (typically not used)
Set Up Mode (typically not used)
Parameter Setting mode
Auto-Tuning
Hz drive set to run
Forward Selection/Reverse Selection (typically not used)
Document Title: Tech Guide ~ Yaskawa V1000 Basic User Guide
Document Revision: v1.0.5
18805 Adams Ct., #110 ~ Morgan Hill, CA 95037, USA ~ +1-408.924.0808 ~ www.washlinksystems.com ~ support@washlinksystems.com
Display
Standard Operator Panel
or to the desired view.
page 3 of 10