Advertisement
UNPACKING THE BOX
Carefully unpack all parts and check that all the parts accessories listed below are included. If any
items are missing, immediately contact the seller.
Accessories:
•
10pc P80 sanding belts – 1 Set
•
13mm Straight arm – 1 Set
•
12mm Cranked arm – 1 Set
•
Instruction manual – 1 Set
ASSEMBLY
WARNING
Before assembly, make sure that the tool is switched off and unplugged.
FITTING AND REMOVING SANDING ARMS (FIG. B)
Before first use, you have to fit the sanding arm to the tool.
•
A straight arm (sanding width 13mm)
•
A cranked arm for grooving and sanding in the centre of
work pieces and for reaching confined areas.
Fitting
1. Make sure that the belt tensioning lever (5) is in the posi-
tion shown (B).
2. Loosen and remove the belt tracking knob (6).
3. Remove the tape retaining the spring (11) (if present).
4. Check that the spring is located in its mounting hole.
5. Position the arm (4) as shown.
6. Fit the belt tracking knob (6) and tighten it until the arm is
aligned with the tool.
Removing
1. Remove the sanding belt (if present) as described below.
2. Loosen and remove the belt tracking knob (6).
3. Remove the arm.
WARNING: Be careful not to lose the spring (11).
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
25
Seite
Advertisement
